400 Series Air Powered Syringe Assemblies
Source: Techcon Systems, Inc.
Air Powered Syringe Assemblies include syringe barrel and stopper.
Air Powered Syringe Assemblies include syringe barrel and stopper. Syringe barrels and tipps are molded from polypropylene; air powered stoppers are molded in polyethylene (-9) or thermoplastic rubber (-2 or -7); syringe plugs are molded in polyethylene. Stopper cleanly empties the barrel and assists in the effciency of dispensing fluids. Use of a tip cap will seal the delivery end of the barrel for additionaly safety when transporting filled barrels. Combined with a Techcon Systems dispenser, these syringe assemblies produce a low cost method of applying all types of fluids.
![Previous Page]()
![Top of Page]()
![Next Page]()
Air Powered Syringe Assemblies include syringe barrels and stoppers. Syringe barrels and needle tips are molded from polypropylene; air powered stoppers are molded in polyethylene (-9) or thermoplastic rubber (-2 or -7); syringe plugs are molded in polyethylene. Stopper cleanly empties the barrel and assists in the efficiency of dispensing fluids. Use of a tip cap will seal the delivery end of the barrel for additional safety when transporting filled barrels. Combined with a Techcon Systems dispenser, these syringe assemblies produce a low cost method of applying all types of fluids.
Techcon Systems, Inc., 12151 Monarch Street, Garden Grove, CA 92841. Tel: 714-799-9910; Fax: 714-799-6804.