G-2360

G-2360 is a synthetic resin adhesive developed for flush door construction. It was designed to give strong, permanent bonds on typical door components such as masonite, wood, MDF, corrugated cardboard, particle board, mineral-based fire insulation, etc. It has been approved for use in the assembly of 20, 45, 60 and 90 minutes fire doors. G-2360 meets or exceeds the requirements as set out in the NWWDA I.S. 1.6-87 for a Type 1 wood flush door adhesive.

Applied by mechanical roller, at a rate of 10-14 mils wet film thickness, G-2360 can be used to assemble a wide variety of hollow and solid core flush doors. Minimum application temperature is 13°C (55°F).

Typical assembly time is approximately 10-20 minutes. The assembled doors should then be placed in press for 30 minutes for proper bond development. G-2360 can also be successfully used on hot presses. Note that when assembling a multi-layer door construction, the surfaces must be sufficiently cooled after each press cycle. This will avoid premature drying of the adhesive film before completing the assembly.

Depending on the construction and types of components used, trimming can be performed as early as 3 hours after removal from the press. Ideally, the delay period before trimming should be extended as long as is convenient to enable the adhesive to develop as thorough a bond as possible.

Physical Properties:

• Viscosity (Summer): 11,000 -13,000 cPs/25°C
  • (Winter): 8,500- 9,500 cPs/25°C
• Solids: 45± 1%
• PH: 5.0 - 6.0
• Specific gravity: 1.08

Shelf Life:
Three (3) months in the original unopened container when stored in a cool, dry area. Protect from freezing.

Dural, Div. Of Multibond, Inc., 550 Marshall Ave., Dorval, PQ H9P 1C9. Tel: 514-636-6230; Fax: 514-631-7737.